Zoeller 268-0030 Waste-Mate Nonauto N268 Submersible Pump 115V w/Cast Iron Impeller

• Durable cast construction. ASTM Class 25 Cast iron, switch case, and pump housing. Cast iron base. Non-Clogging Vortex Impeller Design. Not affected by materials normally found in drainage and sewage sumps. Stainless steel screws, bolts, handle, guard, and arm and seal assembly.
• UL Listed 3-wire neoprene cord and plug, 15 ft. cord standard for Nonautomatic. Longer cord lengths are available at extra cost.
• Square Ring and Gasket - Neoprene. Motor - 266/267/268 Series - 1/2HP 60 Hz, 1725 RPM, oil-filled, hermetically sealed, automatic reset thermal overload protected (1 PH only). Oil lubricated bearings. Carbon and ceramic shaft seal.
• Passes 2-inch spherical solids. Model 268 contains combination 2” NPT Female and 3” NPT Male discharge.
• Corrosion resistant powder coated epoxy finish.
• The sizing of effluent systems normally requires variable level float (s) controls and properly sized basins to achieve required pumping cycles or dosing timers with nonautomatic pumps. May be used in those states where codes do not restrict solids size in effluent systems.

Please Note: Many Zoeller pumps are factory tested at Zoeller to assure top quality & performance. Due to these standard testing practices you may find small dust particles on the unit. This is considered normal and does not impact the performance of the unit.